Epson Stylus Pro 5000 Service Manual page 165

Stylus Pro5000
41. Insert a needle(diameter 2.0mm) for alignment into "Gear,24", and let the
needle pierce to the hole on the "Lever, Roller, Paper Feed, Right", and
fix "Gear,24". (See figure 4-173)
42. Insert a needle(diameter 2.0mm) for adjusting alignment to the hole on
the "Combination Gear,24,24". At this time, insert the needle from big
gear side to the smaller gear side. (See figure 4-174)
Rev. B
"Gear,24"
"Lever, Roller, Paper
Feed, Right"
Needle for adjusting
alignment(diameter 2.0mm)
Figure 4-173. Fixing "Gear,24"
Needle for adjusting
alignment(diameter 2.0mm)
"Combination Gear,24,24"
Figure 4-174. Preparation Before Installing "Combination Gear,24,24"
Chapter4 Assembly and Disassembly
4-91