Assembling Gear Train - Epson Stylus Pro 5000 Service Manual

Stylus Pro5000

4.3.2 Assembling Gear Train

Here explains procedure to assemble gear train. Since assembling gear
train require to have several alignments between gears, it will be almost
impossible to assemble gear train without referring this section.
Therefore, in case of disassembling gear train, make sure to refer to this
section and assemble the gear train. Also, this procedure is written based on
the assumption that the final step(Step26) in the previous section;
Disassembly of Gear Train is completed.
1. Insert "Lever, Stopper, ASF" into axis, and also insert "Combination Gear,
30.30" into the same axis.
CHECK POINT
When installing "Combination Gear,30.30", be
careful of which is top. The bigger gear side is top.
2. Insert "Gear,12.8" into the axis.
CHECK POINT
In case of removing "Gear,12.8", since there is
alignment(engagement) between the gears located
on the "Hopper Release Assembly" and
"Gear,12.8", refer to Figure4-86 and arrange
alignment between these two gears. When moving
"Hopper Release Assembly" right and left
manually, insert "Gear,12.8" into the axis so that
the big gear of "Gear,12.8" can engage with the
big gear on the "Hopper Release Assembly".
Rev.B
"Lever Assembly, Hopper"
Figure 4-85. Installing "Combination Gear,30.30"
"Gear,12.8"
Figure 4-86. Installing "Gear,12.8"
Chapter4 Assembly and Disassembly
"Combination Gear,30.30"
Be careful of which side comes
top.
"Frame Gear" on
the "Hopper Release
Lever Assembly"
4-46