Epson Stylus Pro 5000 Service Manual page 97

Stylus Pro5000
4. Remove only 6, which are located inside, out of 12 "Tube, Locking
Screw"s securing 6 ink tubes respectively, and remove ink tubes.
(Refer to Figure4-41)
WARNING
After removing each ink tube from "Relay, Tube",
handle it so that the tip of the tune does not face
down but face up. Otherwise, ink charged in the
tube may leak out.
4. Remove 2 CBS screws(3x6) securing "Reinforcing board, Fixing, FFC" to
the mechanism, and remove ink tubes for each color with dampers.
5. From left side of the printer mechanism, remove "E" shaped ring securing
"Combination gear,36.36.67", and remove "Combination gear, 36.36.67".
(Refer to Figure4-42)
CHECK POINT
There is alignment between "Combination Gear,
36,36.67" and "Gear,49". When assembling them,
install them to each axis, matching "O" marked on
the both gear surface(red circle in the figure4-42).
Rev. B
Chapter4 Assembly and Disassembly
CBS(3x6)
"Tube, Locking Screw"
"Relay, Tube"
"Reinforcing, Fixing, FFC"
Figure 4-41. "Tube, Locking Screw" Removal
Gear,49
Combination Gear,36.36.67
Figure 4-42. "Combination Gear,36.36.67"
"Tube, Locking Screw"
"Relay, Tube"
"E" shaped ring(#6)
4-23