Epson Stylus Pro 5000 Service Manual page 155

Stylus Pro5000
CAUTION
In the figure4-152, the hole written "Caution" is for
installing "Upper Surface Sensor". Do not install
"Curl Unit" to this hole.
16. Insert "Harness, Upper Surface Sensor" to "Sensor, HP".
(See figure4-153)
17. Install "Sensor, HP" to "Mounting Board Assembly, Upper Surface
Sensor". (See figure4-154)
Fixing CBP Screws(3x8)
Nails for Adjusting Alignment
(diameter of nail:2.0mm)
Figure 4-152. Installing "Curl Unit" at Right Side
Rev. B
Right side of "ASF Unit"
Caution
Chapter4 Assembly and Disassembly
"Sensor, HP"
"Harness, Upper
Surface Sensor"
Figure 4-153. Setting "Upper Surface Sensor"(1)
"Mounting Board Assembly,
Upper Surface Sensor"
"Sensor, HP"
Figure 4-154. Setting "Upper Surface Sensor"(2)
4-81