Epson Stylus Pro 5000 Service Manual page 144

Stylus Pro5000
4. Pull out "Axis, Paper Feed, Roller Set" from "ASF Unit".
(See figure4-129)
5. Reverse "ASF Unit", and take "Compression Spring, 0.98" out.
CAUTION „ When installing "Compression Spring,0.98"
again, apply "Neji Lock"(Screw Lock) on the
"Lever, Roller, Paper Feed, Left".
„ Note that each compression spring attached to
"Lever, Roller, Paper Feed, Left" and "Lever,
Roller, Paper Feed, Right" is different. The
number of coil(spring strength) is different.
6. Remove one "E" shaped ring (4, F/Uc) from "Axis, Paper Feed, Fixing".
(See figure4-130)
Rev. B
Chapter4 Disassembly and Assembly
"Axis, Paper Feed, Roller Set"
Figure 4-129. "Axis, Paper Feed, Roller Set" Removal
"E" shaped ring
(4,F/Uc)
"Compression
Spring,0.98"
"Lever, Roller,
Paper Feed, Left"
Figure 4-130. "Axis, Paper Feed, Fixing" Removal
"Axis, Paper
Feed, Fixing"
4-70