Epson Stylus Pro 5000 Service Manual page 151

Stylus Pro5000
4. Insert "Lever Assembly, Curl" to the axis on the "Holder, Lever, Curl",
placing "Lever Assembly, Curl" vertically, as it is shown in figure4-144.
After inserting, make sure that some space is left between "Lever
Assembly, Curl" and the protrusion on the "Gear,24", as it is shown in
figure4-144.
5. Remove the needle once.
6. Move the "Lever Assembly, Curl" toward arrow direction(toward "Gear
10"), as it is indicated in figure4-145, until it stops. At this time, make sure
that hinge part of "Lever Assembly, Curl" is pierced through the inside of
protrusion on the "Gear, 24". (See figure4-145)
Rev. B
Chapter4 Assembly and Disassembly
There should be
some space.
Protrusion
"Lever Assembly, Curl"
Figure 4-144. Setting "Lever Assembly, Curl(1)"
Hinge Part
Protrusion
Figure 4-145. Setting "Lever Assembly, Curl(2)"
4-77