Epson Stylus Pro 5000 Service Manual page 104

Stylus Pro5000
8. Remove "E" shaped ring(#3) securing "Stopper, CR, Lock", and remove
"Stopper, CR, Lock". (Refer to Figure4-55)
WARNING
When removing "E" shaped ring(#3), following
parts may jump out. So, be careful no to lose
them.(The Number below is listed from exterior
side)
1. "Spacer, CR, Lock"
2. Plain washer(5.07x0.3x10)
3. Compression spring,5.85
4. Spacer, Roller PF,B
5. Plain washer(5.07x0.3x10)
6. Plain washer(4.4x0.5x14)
7. Plain washer(4.4x0.5x14)
8. Bush, 8B
Refer to Figure4-56 and check shapes of each
parts.
9. From left side of the mechanism, remove one "E shaped ring(#7), and
remove PF roller. (Refer to Figure4-57)
"E" shaped ring(#2.3)
"Stopper, CR, Lock"
"E" shaped ring(#3)
Figure 4-55. "Stopper, CR, Lock" and "Lever, CR, Lock" Removal
Rev.B
"Lever, CR, Lock"
Plain washer(4.4x0.5x14)
Plain washer(4.4x0.3x10)
Plain washer(5.07x0.3x10)
"Spacer, Roller, PF,B"
"Stopper, CR, Lock"
"E"shaped ring(#3)
Figure 4-56. The order to install parts at re-installing "Stopper, CR,
PF Roller
Figure 4-57. PF Roller Removal
Chapter4 Assembly and Disassembly
Bush, 8B
Compression spring,5.85
Plain washer(5.07x0.3x10)
"Spacer, CR, Lock"
Lock"
"E"shaped ring(#7)
4-30