Epson Stylus Pro 5000 Service Manual page 125

Stylus Pro5000
CHECK POINT
In the condition that alignment of "Hopper
Transmission Gear Assembly" is made correctly,
as it is shown in Figure4-95, in the inside of
"Frame, Assembly, Middle, Right", the protrusion
of "Cam Assembly, Paper Return" should be
inserted into the ditch of "Lever, Paper Return,
Cam" and also 5 paper return levers should be
sticking out.(Refer to Figure4-95 and Figure4-96)
11. Hang "Timing Belt, Hopper" on the "Combination Gear, 18.144,24".
(Refer to Figure4-97)
Protrusion
"Cam, Assembly,
Paper Return"
Figure 4-95. Frame Inside After Adjusitng Alignment of "Hopper Lock
Transmission Gear, Assembly"
Rev.B
Ditch
"Lever, Paper
Return, Cam"
Figure 4-96. Paper Return Lever After Adjusting Alignment of "Hopper
Lock Transmission Gear Assembly"
"Timing Belt, Hopper"
"Combination Gear,18.144,24"
Figure 4-97. Setting "Timing Belt, Hopper"
Chapter4 Assembly and Disassembly
Paper Return Lever should be
sticking out.
4-51