Epson Stylus Pro 5000 Service Manual page 189

Stylus Pro5000
Step10. Refer to figure 5-31, and move the lever to appropriate
direction after checking the lever position and tendency of
pattern changes. Then, press Return key on the program
again and execute printing.
Step11. Press Eject button on the control panel and check the
result of the printed pattern.
Step12. Refer to O.K pattern in the figure5-29, and repeat Step4
through 11 until the head height adjustment is completed.
Step13. Tighten a screw (2 screws if both heads are replaced) to fix
the head completely, and install the cover over the carriage
by one screw.
Step14. Install the upper case.
Step15. Perform the next section 5.1.1.6 "Head Gap Adjustment".
Rev. A
Chapter5 Adjustment
5-21