Epson Stylus Pro 5000 Service Manual page 119

Stylus Pro5000
23. Remove the timing belt, which is installed between "Hopper Lock
Transmission Gear Assembly" and "Combination Gear,18.144,24".
(Refer to Figure4-84)
CHECK POINT
In case of removing "Timing Belt, Hopper", it is
necessary to match the alignment at re-installing.
Refer to section 4.3.2 "Assembling Gear Train"
and assemble gear train.
24. Remove "Hopper Lock Transmission Gear Assembly" from axis.
(Refer to Figure4-84)
CHECK POINT
In case of removing "Hopper Lock Transmission
Gear Assembly", it becomes necessary to match
the alignment at re-installing. Refer to section
4.3.2 "Assembling Gear Train" and assemble gear
train.
25. Remove "Combination Gear,18.144,24" from axis. (Refer to Figure4-84)
CHECK POINT
In case of removing "Combination
Gear,18.144,24", it becomes necessary to match
the alignment at re-installing. Refer to section
4.3.2 "Assembling Gear Train" and assemble gear
train.
26. Remove "Cam ASF Assembly". (Refer to Figure4-84)
CHECK POINT
In case of removing "Cam ASF Assembly", it
becomes necessary to match the alignment at re-
installing. Refer to section 4.3.2 "Assembling Gear
Train" and assemble gear train.
Rev.B
"Combination Gear,18.144,24"
"Gear,32"
Figure 4-84. "Cam ASF Assy", "Timing Belt, Hopper", "Gear,32",
"Combination Gear,18.144,24" and "Hopper Lock Transmission Assy"
Chapter4 Assembly and Disassembly
"Cam ASF Assembly"
"Timing Belt, Hopper"
"Hopper Lock Transmission
Gear Assembly"
Removal
4-45