Epson Stylus Pro 5000 Service Manual page 199

Stylus Pro5000
Step18. Following screen appears.(Example in the figure; Normal Dot)
Figure 5-48. Inputting Bi-D Adjustment Value
Step19. Input assumed center value, using up and down key.
(Following screen appears)
Figure 5-49. Determining Bi-D Adjustment Value
Rev. A
Step20. If you need to continue adjustment for other dot types, press
ESC key one time and go back to the screen of figure5-47,
then repeat Step17 through 19. If you need not to continue
adjustment, move to Step21.
Step21. Press ESC twice and go back to the screen of figure5-44,
then select "Print out Bi-D pattern".
Step22. Repeat Step12 through Step 21and continue adjustment until
the correct printing sample (each even and odd line match) is
found.
Step23. After adjustment is completed, press ESC key for 4 times and
finish the program.
CAUTION
When the program is finished at Step23, since the
power off command is always output, the printer
is turned off completely. However, this is not the
malfunction. By this command, the adjustment
values are surely registered in the EEPROM.
Chapter5 Adjustment
5-31