Epson Stylus Pro 5000 Service Manual page 152

Stylus Pro5000
7. Insert "Compression Spring, 0.399" to "Lever Assembly, Curl".
(See figure4-146)
CAUTION
When installing "Compression Spring, 0.399",
hang the one side of "Compression Spring, 0.399"
to the protrusion "A" first, then insert the other
side to "B" surface part of axis, pushing it.
8. Cover with "Cover, Guide, Curl", and fix it with one CPS screw(3x15) from
the back(opposite) side.
CAUTION
When covering "Cover, Guide Curl", see the
figure4-147 and fix it with a screw after checking
that following 3 points are in the correct positions.
Point 1:Fook is out side of the frame, and frame
and hook are overlapped.
Point 2:Hook is out side of the frame, and frame
and hook are overlapped.
Point 3: "Gear, 10" is firmly attached by the
frame.
Rev. B
Chapter4 Assembly and Disassembly
"Compression
Spring 0.399"
Protrusion"A"
Figure 4-146. Setting "Compression Spring,0.399"
Details for Point 3
"Cover, Guide, Curl"
"Gear,10"
Point 1
Figure 4-147. Installing "Cover, Guide, Curl"
Axis "B"
Point 3
Point 2
4-78