Epson Stylus Pro 5000 Service Manual page 96

Stylus Pro5000
4.2.5.11 Frame, Main, Paper Eject Removal
1. Remove print head. (See section4.2.5.3)
2. Remove each 2 CBS screws(3x30) securing "Holder, Fixing, Tube, B",
and remove "Holder, Fixing, Tube, B" from the mechanism.
(Refer to Figure4-39)
CHECK POINT
"Holder, Fixing, Tube, B" located both right and
left sides are exclusive ones. Therefore, before
reinstalling them, check "L"(for left) and "R"(for
right) written on the surface of "Holder, Fixing,
Tube, B" and install them correctly.
3. Perform prevention for ink leakage to 6 dampers, which are removed
from print head.
WARNING
Removing "Tube, Locking Screw" in the condition
that the print head is removed has a risk of ink
leakage from damper side. This may make
clothing or mechanism dirty. In order to prevent
this, have a container in advance, which can
absorb ink leakage from the damper, and put the
damper in it. (See Figure4-40)
Rev. B
Chapter4 Assembly and Disassembly
"Holder,Fixing,Tube, B"
L
CBS(3x30)
Figure 4-39. "Holder, Fixing, Tube, B" Removal
Figure 4-40. Preventing Ink Leakage
R
CBS(3x30)
4-22