Lubrication And Adhesion - Epson Stylus Pro 5000 Service Manual

Stylus Pro5000

6.3 LUBRICATION AND ADHESION

Both grease, oil and adhesive give great influence on printer's endurance.
EPSON determines the type of oil and grease based on the results of
internal evaluations. Grease or oil should be applied for the parts that their
lubrication are worn out by cleaning, disassemble/assemble, or parts
replacement. Adhesive should be used for assembly or parts replacement.
T T
CAUTION
Never use the grease, oil and adhesive other
than those specified in this manual. Using
different type of lubricant can damage the
printer and components.
T T
Never apply the exceeding the amount of grease
or adhesive, in order to prevent function failure.
Table 6-2. Specified Lubricants and Adhesive
Type Name Amount
Grease G-26 40g
G-20 40g
Oil 0-8 40g
Adhesive Screw lock 1000g
1410B
Rev. A
EPSON Code Application
B702600001 EPSON
exclusive
B702000001 EPSON
exclusive
1019753 EPSON
exclusive
B730200200 EPSON
exclusive
Table 6-3. Lubricating Points
No. Lubricating Points
1 Inside of 2 gear areas of "Cam, ASF".
2 2 contact areas; "Cover Assembly, Lifter" and
"Lever assembly, Lifter Clutch".
3 2parts; Top and bottom of A axis , "Frame
Assembly, Middle Right".
4 2 parts; Top of "E-shaped retaining ring" and
A axis of "Frame Assembly, Middle, Right".
5 From "Lever Assembly, Planetary Gear, Sub"
on the "Frame, Assembly, Middle, Right" of F
axis to the ditch on the axis.
6 G axis of "Frame Assembly, Middle, Right".
7 Bent area located on the tip of "Lifter Gear
Train Cover Assembly".
8 Contact area between "Frame Assembly
Middle Right", and "Lever Assembly Hopper".
9 Rib of "Cam Assembly, Paper Return "
10 5 contact areas; "Lever Assembly, Paper
Return A and B" located under the "Paper
Lower Guide". (Although only 2 points are
indicated in the figure, lubricate the rest of 3
points which are similarly located as indicated
2 points in the figure.)
11 2 contact areas between "Reinforcing Plate,
Assembly, Base" and "Mounting Board,
Rotary damper".
12 Gear teeth of Gear 11.5.
13 2 parts on the slope of "Cam Disengage".
14 Gear teeth of Combination Gears 14.4, 21.6.
15 Teeth surface of the bigger "Combination
gear 15" (compared with the combination
gear 12)
16 Axis of "Frame assembly, DE, Right".
Note) means diameter.
Chapter6 Preventive Maintenance
Type/Amount
G-26 ( 1x2mm)
G-26 ( 1x2mm)
G-26 ( 1x2mm)
G-26 ( 1x2mm)
G-26 ( 1x25mm)
G-26 ( 1x2mm)
G-26 ( 1x2mm)
G-26 ( 1x2mm)
G-26 ( 1x2mm)
G-26 ( 1x5mm)
G-26 ( 1x1mm)
G-26 ( 1x1/3 of
gear teeth)
G-26 ( 1x5mm)
G-26(1/3 of gear
teeth)
G-26 ( 1x1/3 of
gear teeth)
G-26( 1x10mm)
6-4