Epson Stylus Pro 5000 Service Manual page 136

Stylus Pro5000
36. At first, stick the gear part of "ASF Unit" out through the square hole,
and lift up the other side of frame up to the fixing position, and leave it on
the fixing position.
CHECK POINT
At this time, match "U" shaped ditch of "Mounting
board, Stopper, Paper, Left" and "Axis, Paper
Feed" on the "ASF Unit". (Refer to Figure4-117)
37. Refer to the following procedure in order to make the flat side of "Roller,
Paper Feed" face down.
38. Lift up the gear side of "ASF Unit" lightly, and make the flat side of
"Roller, Paper Feed" face down by rotating "Combination Gear,24,24" or
"Roller, Paper Feed". (Refer to Figure4-118)
Rev. B
Chapter4 Assembly and Disassembly
"Mounting Board, Stopper,
Paper, Left"
Figure 4-117. Installing ASF
1.
1.Lif it up lightly.
2.Rotate "Combination Gear,24,24".
Figure 4-118. Condition Changes of "Roller, Paper Feed"
"Axis, Paper Feed"
"U" shaped ditch
2.
4-62