Epson Stylus Pro 5000 Service Manual page 131

Stylus Pro5000
29. Insert "Gear, 31.8" into the same axis, which "Combination
Gear,18.144,24" is installed, and insert "Gear,17.4" into an axis located at
right next side. (Refer to Figure4-109)
30. Insert an axis on the "Lever Assembly, Planetary, ASF" and an axis on
the "Gear,17.4" into 2 holes on the "ASF Gear Train Cover Assembly",
and tighten 2 CBS screws(3x6) on the axes of "Gear,35.4" and
"Gear,31.8". (Refer to Figure4-110)
CHECK POINT
When installing "ASF Gear Train Cover
Assembly", install it after checking that the angle
of "Lever Assembly, Planetary, ASF" is tilted
toward left, as it is shown in Figure4-110.
Rev.B
Chapter4 Assembly and Disassembly
"Gear,31.8"
"Gear, 17.4"
Figure 4-109. Installing "Gear,31.8" and "Gear,17.4"
"Lever Assembly, Planetary, ASF"
Positioning holes
"Gear, 35.4"
CBS(3x6)
"Gear,31.8"
Figure 4-110. Installing "ASF Gear Train Cover Assembly"
"ASF Gear Train Cover
Assembly"
4-57