Epson Stylus Pro 5000 Service Manual page 140

Stylus Pro5000
42. Install "Lever Belt Tension" and "Torsion Spring,1.27".
(Refer to section 4.3.1., Figure4-79 and 4-80)
43. Install "Lever, Hopper", then, also install "Tension Spring,0.588".
(Refer to section 4.3.1, Figure4-77)
44. Install "Lever, Hopper, Lock", then install "Tension Spring,25.5".
(Refer to section 4.3.1, Figure4-77)
CHECK POINT
Install "Lever, Hopper Lock", pressing "Hopper,
Release, Lever". (Refer to section 4.3.1, Figure 4-
77 for more details)
45. Install "Gear,17.4". (Refer to Figure4-124)
46. Install "Clutch, Lifter" and "Gear,27.6" with "Torsion Spring,1.77".
(Refer to Figure4-124)
CHECK POINT
Before installing "Clutch, Lifter", make sure that
tension of "Torsion Spring,1.77" located inside is
working. (Refer to section 4.3.1, Figure4-74 76 for
more details)
47. Install "Combination Gear, 12,25.8".(Refer to Figure4-124)
Rev. B
"Torsion Spring,25.5"
"Gear,17.4"
"Lever, Hopper, Lock"
"Combination Gear,
12.25.8"
"Torsion Spring,1.27"
"Lever Belt Tension"
Figure 4-124. Installing the rest parts of "Frame Assembly, Middle,
Right"(1)
Chapter4 Assembly and Disassembly
"Tension Spring,
0.588"
"Lever, Hopper"
"Clutch, Lifter"
"Gear,27.6"
4-66