Epson Stylus Pro 5000 Service Manual page 118

Stylus Pro5000
19. Release "Torsion Spring,3.92" which is giving tension to "Lever, Stopper,
ASF", and remove "Lever, Stopper, ASF". (Refer to Figure4-82)
20. Remove "Combination Gear,30.30", and remove "Lever Assembly,
Hopper".
21. Remove "Combination Gear,13.8,17.4". (Refer to Figure4-82)
22. Remove "Gear,12.8". (Refer to Figure4-82)
CHECK POINT
In case of removing "Gear,12.8", since there is
alignment(engagement) between the gear located
on the "Hopper Release Assembly" and
"Gear,12.8", refer to Figure4-83 and arrange
alignment between these two gears. When moving
"Hopper Assembly" right and left manually, insert
"Gear,12.8" into the axis so that the big gear of
"Gear,12.8" can engage with the big gear on the
"Hopper Release Assembly".
Rev.B
"Torsion Spring,3.92"
"Lever, Stopper, ASF"
"Combination Gear,30.30"
Figure 4-82. "Lever, Stopper, ASF" ,"Combination Gear 13.8.17","Lever,
Stopper, ASF", "Gear,12.8", "Combination Gear,13.8, 17.4", "Lever
Assembly Hopper" Removal
"Gear,12.8"
Figure 4-83. Adjusting alignment for "Gear, 12.8"
Chapter4 Assembly and Disassembly
"Combiantion Gear,13.8,17.4"
"Lever Assembly, Hopper"
"Gear, 12.8"
"Frame Gear" on
the "Hopper Release
Lever Assembly"
4-44