Epson Stylus Pro 5000 Service Manual page 26

EPSON Stylus Pro 5000
PANEL SETTING FUNCTION
Here explains input method for each panel setting.
T
Printing nozzle check pattern and printer configuration
Operation: Reset SW + Power On
Exit: Power Off
Function: (Power LED blinking while in this mode)
1)Reset SW + Power on
to thick 3)Starts printing pattern
4)Printing 1-page 5)Eject paper 6) Stand by
mode in self-test by pressing
followings.
[Pressing Cleaning SW: in standby mode only]
1)Execute cleaning 2)Eject paper 3)Reprint self test
page 4)self-test stand by mode.
[Pressing Eject SW: in standby mode only]
1)Feed paper 2)Reprint self test page 3)self-test
stand by mode.
Note) Ignore Cleaning SW while printing and Power off to exit this mode.
T T
CHECK POINT
Even if Cleaning or Eject switch is pressed
during printing, the panel operation is ignored.
T T
You can escape from the self-test mode only by
turning the power off.
Printing Pattern: Print nozzle test pattern, firmware version, the value
of wasted ink count and current setting values are
printed. Following shows printing pattern.
Rev.A
2)Position change
Refer to
[Explanation]
K00227A:
A:0D95 :
Chapter1 Product Description
Figure 1-3. Printing Sample
Firmware version.
The present counting value of ink absorber only for
dark colors head.
1-16