4.2.10.3 PF Gear Train Disassembly
1.
Remove the printer mechanism. (See Section 4.2.9.)
2.
Remove the CR motor. (See Section 4.2.10.1.)
3.
Remove the PF motor. (See Section 4.2.10.2)
4.
Remove the head FFC from the FRAME,SUB,RIGHT of the printer mechanism.
5.
Remove the 2 CBS (M3
FRAME,SUB,RIGHT.
Verify to properly mesh the release lever with the teeth of
CHECK POINT
Assembly to engage the hole of CAM,CLUTCH,TRACTOR with the
Rev. A
8) screws securing the FRAME,SUB,RIGHT, and remove the
Figure 4-13. PF Gear Train Disassembly
INTERMITTEN GEAR as shown below;
Engagement between Release Lever and INTERMITTENT GEAR
ejection part of the release lever.
Chapter 4 DISASSEMBLY AND ASSEMBLY
Figure 4-14.
FX-880 Service Manual
4-17