Auger High Assembly Removal (Pl8.1.40) - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

3.2.11.7 AUGER HIGH ASSEMBLY Removal (PL8.1.40)

1. Remove the TOP COVER ASSEMBLY. (See Section 3.2.4.3.)
2. Remove the REAR COVER ASSEMBLY. (See Section 3.2.4.5.)
3. Remove the DRUM CARTRIDGE. (See Section 3.2.9.1.)
4. Remove the TENSION LEVER. (See Section 3.2.11.1.)
5. Remove the INNER COVER ASSEMBLY. (See Section 3.2.4.4.)
6. Remove the MSI TRAY ASSEMBLY. (See Section 3.2.7.1.)
7. Pull out the MAIN P/H ASSEMBLY with the MSI ASSEMBLY on it.
(See Section 3.2.8.1.)
8. Remove the ROS ASSEMBLY. (See Section 3.2.9.3.)
9. Remove the ADC SENSOR ASSEMBLY. (See Section 3.2.9.4.)
10. Remove the XL RAIL ASSEMBLY. (See Section 3.2.9.5.)
11. Remove the FUSER ASSEMBLY with the EXIT TRAY ASSEMBLY
and the OIL ROLL ASSEMBLY. (See Section 3.2.12.2.)
12. Remove the HVPS. (See Section 3.2.16.2.)
13. Remove the TRANSFER ASSEMBLY. (See Section 3.2.11.2.)
14. Remove the BTR CAM SOLENOID. (See Section 3.2.11.3.)
15. Remove the BELT CLEANER ASSEMBLY. (See Section 3.2.11.4.)
16. Remove the 2ND BTR ASSEMBLY. (See Section 3.2.11.5.)
17. Remove the 2ND BTR CAM ASSEMBLY. (See Section 3.2.11.6.)
Chapter 3 Disassembly and Assembly/Adjustment
18. Remove the RIGHT COVER ASSEMBLY. (See Section 3.2.4.8.)
19. Remove the CONTROLLER PWB. (See Section 3.2.17.1.)
20. Remove the CONT. CHASSIS ASSEMBLY. (See Section 3.2.17.3.)
21. Remove the screw (silver, 6mm) securing the CRUM CONNECTOR
ASSEMBLY and remove the CRUM CONNECTOR ASSEMBLY.
22. Remove the screw (gold, with a washer, 8mm) securing the AUGER
HIGH ASSEMBLY at the back.
Figure 3-86. AUGER HIGH ASSEMBLY Removal (1/3)
Revision A
3-72