Epson ColorPage EPL-C8200 Service Manual page 342

EPSON ColorPage EPL-C8200
uuuu Toner Low
LED: No effect on LED state.
Explanation: The engine has detected (by measuring the dispense
time) the toner level for one or more Toner Cartridges
has fallen below 80%. The uuuu area indicates which
Toner Cartridge is low, Y, M, C, or K.
Solution: Do one or more of the following to clear the warning
message.
1. Press the Continue button.
2. Perform a Reset operation.
3. Replace the indicated toner cartridge with a new
one.
Warning Photocondctr
LED: No effect on LED state.
Explanation: The photoconductor unit is approaching the end of its
life. The engine's detection system calculates the
remaining lifetime, and generates this message
when the number of pages left approaches:
- Color print:
- Black print:
Solution: It is recommended that the photoconductor unit be
replaced when this message appears (although it is
possible to continue using the existing unit until the
"Replace Photocondctr" error occurs). Do any of the
following to clear the warning message.
1. Press the Continue button.
2. Perform a Reset operation.
3. Replace the photoconductor unit with a new one.
Chapter 5 Troubleshooting
1,125 pages (A4, 4.5% duty)
4,500 pages (A4, 4.5% duty)
Waste T Box Nearfull
LED: No effect on LED state.
Explanation: The Waste Toner Box is almost full. (The engine's
detection system calculates the level of waste toner,
and generates this message when the Waste Toner
Box is almost full.)
Solution: It is recommended that the Waste Toner Box be
replaced when this message appears (although it is
possible to continue using the existing box until the
"Replace Waste T Box" error occurs). Do any of the
following to clear the warning message.
1. Press the Continue button.
2. Perform a Reset operation.
3. Replace the Waste Toner Box with a new one.
Oil Roll Near Empty
LED: No effect on LED state.
Explanation: The fuser oil is running low. (The engine's detection
system calculates the remaining level of fuser oil,
and generates this message when it determines that
the fuser oil will run out after printing 1,000 more
pages (A4, 5% duty, black print: color print=1:1).
Solution: It is recommended that the Fuser Oil Roll be replaced
when this message appears (although it is possible
to continue using the existing oil roll until the
"Replace Oil Roll" error occurs). Do any of the
following to clear the warning message.
1. Press the Continue button.
2. Perform a Reset operation.
3. Replace the Fuser Oil Roll with a new one.
Revision A
5-14