Epson ColorPage EPL-C8200 Service Manual page 279

EPSON ColorPage EPL-C8200
Slave Read
In the [Slave Read] page, you can read the contents of the [Slave].
NOTE: Before you run [Slave Read], make sure that the communication
has been established. If you run [Slave Read] when the
communication has not been established, the Diagnostic
Commander may hang up.
1. Click the [Slave Read] button.
2. The data read from the Slave is displayed, as shown below:
Table 4-8. Contents of the Master
Serial No. Header (top 4-digit)
BTN0
[OEM Code] 03
[Part No.] 62042
[Serial No.] A unique Serial No. for the product (last 6-digit.).
These values must be the same as appeared in [Master Read]. If
not, you need to perform [Slave Initialize] described in the next
section.
Chapter 4 Diagnostics
BYM0 BYN0 BYP0
03 03 03
62025 62026 62027
Slave Initialize
In the [Slave Initialize] page, you can initialize (erase) the [Slave] data.
Do not run [Slave Initialize] unless instructed to do so
in this manual.
NOTE: Before you run [Slave Initialize], make sure that the
communication has been established. If you run [Slave Initialize]
when the communication has not been established, the
Diagnostic Commander may hang up.
1. Click the [Slave Initialize] button.
2. The [Slave] is initialized.
NOTE: After you initialize the [Slave], turning the power ON/OFF
automatically writes the data in the Slave.
NOTE: There may be more tasks you need to do before turning the
power ON/OFF after the Slave initialization. Follow the
instructions in this manual.
Revision A
4-15