Roll Assembly Removal (Pl10.2.7); Fuser Fan Removal (Pl10.2.15) - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200
3.2.13.5 EXIT-3 ROLL ASSEMBLY Removal (PL10.2.7)
1. Remove the TOP COVER ASSEMBLY. (See Section 3.2.4.3.)
2. Remove front and rear E-rings securing the EXIT-3 ROLL
ASSEMBLY.
3. Remove the SPUR GEAR, EXIT FRONT BEARING and EXIT
REAR BEARING.
4. Remove the EXIT-3 ROLL ASSEMBLY.
Figure 3-118. EXIT-3 ROLL ASSEMBLY Removal
Chapter 3 Disassembly and Assembly/Adjustment

3.2.13.6 FUSER FAN Removal (PL10.2.15)

1. Draw out the FUSER ASSEMBLY.
2. Remove the REAR COVER ASSEMBLY. (See Section 3.2.4.5.)
3. Disconnect the connector (P/J111B) for the FUSER FAN and
release the harness from the clamp.
4. Widen the hooks securing the FUSER FAN and remove the FUSER
FAN.
Figure 3-119. FUSER FAN Removal
When placing the FUSER FAN, make sure the
fan is installed with the maker label facing
outward.
Revision A
3-97