Roll Assembly Removal (Pl9.3.7) - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200
3.2.12.19 EXIT-1 ROLL ASSEMBLY Removal (PL9.3.7)
1. Remove the EXIT TRAY ASSEMBLY. (See Section 3.2.13.1.)
2. Remove the OIL ROLL ASSEMBLY. (See Section 3.2.12.1.)
3. Remove the FUSER ASSEMBLY. (See Section 3.2.12.2.)
4. Remove the MAIN FUSER ASSEMBLY. (See Section 3.2.12.3.)
5. Remove the E-ring securing the EXIT-1 ROLL ASSEMBLY.
6. Push the front EXIT-1 BEARING to the rear and slide the front part
of the EXIT-1 ROLL ASSEMBLY to the right.
NOTE: In the following step, be careful not drop the EXIT-1
BEARING at the rear end of the EXIT-1 ROLL ASSEMBLY
since it will be released from the FUSER TRAY.
7. Shift the EXIT-1 ROLL ASSEMBLY forward to release the rear end
and remove the EXIT-1 ROLL ASSEMBLY to the rear along with the
EXIT-1 BEARING and the EXIT-1 GEAR.
8. Remove the EXIT-1 BEARING and the EXIT-1 GEAR from the
EXIT-1 ROLL ASSEMBLY.
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-112. EXIT-1 ROLL ASSEMBLY Removal
Revision A
3-93