Epson ColorPage EPL-C8200 Service Manual page 262

EPSON ColorPage EPL-C8200
10. See the output and check that the darkness of the area which was
pressed has changed. Measure the width of the changed area at the
following 2 points:
Points: 1) 15mm inward from the right edge.
2) 15mm inward from the left edge
If the result satisfies the following 2 points, adjustment is correctly
done.
-The width of each end is 4.8 mm 0.2mm
- The difference in the width between 2 ends is 0.2 mm or less.
MAIN FUSER ASSEMBLY Adjustment (3/3)
Chapter 3 Disassembly and Assembly/Adjustment
11. If the result is not satisfactory, return to the step 4 and turn the NIP
(A) in the direction shown below according to the result:
The width is too narrow: Turn the screw clockwise
The width is too wide:
12. Perform the steps 7 to 10 until the result is good.
NOTE: Repeat the procedure promptly while the MAIN FUSER
ASSEMBLY is still hot enough.
Revision A
Turn the screw counterclockwise
3-119