Fip-1.41 Sd-Ram (Slot S0, S1, S2) Related Error - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

FIP-1.41 SD-RAM (SLOT S0, S1, S2) Related Error

Step Check point
Perform the preliminary inspection below:
• Remove all optional electrical unit modules to return the
printer to the standard condition.
1
• Check that all connectors are properly connected to the
CONTROLLER PWB.
Check: SD-RAM
1.Remove all SD-RAMs from the SD-RAM slots 0,
1, and 2.
2.Check that the printer is turned off.
3.Install a SD-RAM to slot 1 and turn the printer on.
4.Repeat the steps 2 and 3 to add other SD-RAMs
one by one to the slot 1 and 2.
2

Is there any defective SD-RAM?
NOTE:
• Be sure to install a SD-RAM whose memory is more
than 32MB in the slot 0.
• Before reinstalling each SD-RAM, verify the correct
direction for installing it; and insert it to the socket until it
is locked.
Chapter 5 Troubleshooting
Yes
Replace/reinstall the defective part(s).
Replace/reinstall the defective part.
Remedy
No
Go to Step 2.
-
Revision A
5-57