Msi Roll Assembly Removal (Pl4.2.9) - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

3.2.7.12 MSI ROLL ASSEMBLY Removal (PL4.2.9)

1. Remove the MSI TRAY ASSEMBLY. (See Section 3.2.7.1.)
2. Remove the MSI ASSEMBLY. (See Section 3.2.7.2.)
3. Remove the MSI FRONT COVER. (See Section 3.2.7.3.)
4. Remove the MSI REAR COVER. (See Section 3.2.7.4.)
5. Remove the MSI TOP COVER ASSEMBLY. (See Section 3.2.7.5.)
6. Remove the PICK UP SPRING from the CLUTCH BRACKET and
PICK UP GEAR.
7. Release the hook for the PICK UP GEAR from the shaft and remove
the PICK UP GEAR from the MSI ROLL ASSEMBLY.
8. Remove the PICK UP CAM GEAR, LEVER STOPPER, and CAM
GEAR SPRING by one unit.
NOTE: In the following step, be careful with MSI BOTTOM
ASSEMBLY, as it springs up while the MSI ROLL
ASSEMBLY is being removed.
9. Remove 2 E-rings securing the MSI ROLL ASSEMBLY, and remove
2 MSI BEARINGs.
10. Lift up the MSI ROLL ASSEMBLY and remove the MSI ROLL
ASSEMBLY.
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-38. MSI ROLL ASSEMBLY Removal


Install the PICK UP CAM GEAR to the MSI ROLL
ASSEMBLY with the arm of the PICK UP SOLENOID
and the GEAR LEVER pressed down.


After installing the MSI ROLL ASSEMBLY, check that
the notch on the PICK UP CAM GEAR is held at the
arm of the PICK UP SOLENOID. (with the PICK UP
ROLL top and the cam of the PICK UP CAM bottom)


When installing the MSI BEARING in the front, note
following:
- Do not bend the earth plate of the MSI FRAME.
- The bearing is in full contact with the grounding
plate.
Revision A
3-35