EPSON ColorPage EPL-C8200
3.2.17 Controller
3.2.17.1 CONTROLLER PWB Removal (PL 14.1.10)
1. Remove the RIGHT COVER ASSEMBLY. (See Section 3.2.4.8.)
2. Disconnect 2 connectors (P/J310 and P/J314) for the
CONTROLLER PWB.
3. Remove 8 screws (silver, cup head, 8mm) securing the
CONTROLLER PWB by the bottom area.
4. Remove 6 screws (silver, cup head, 8mm) securing the
CONTROLLER PWB by the top are.
5. Remove 4 screws (silver, cup head, 8mm) securing the CONT.
PLATE ASSEMBLY.
6. Remove the CONTROLLER PWB slowly, watching the connector
for the CONTROLLER PWB and the MCU PWB behind the
CONTROLLER PWB to avoid damage.
When replacing the Controller PWB, be sure to move
the following items from the current board to the new
one.
Standard
Code DIMM (socket P), SD-RAM DIMM (slot S0),
EEPROM (IC504)
Option
SD-RAM DIMM (slot S1, S2), DIMM module* (socket
A, B, C), HDD Unit, Type-B I/F card
*: Do not instal the DIMM to a wrong slot, since the
DIMM must be set to the specified slot.
Chapter 3
Disassembly and Assembly/Adjustment
4)
4)
2)
3)
Figure 3-143. CONTROLLER PWB Removal
Revision A
4)
2)
3)
5)
3-116