Fip-1.11 Ohp Sheet Is Improperly Set - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

FIP-1.11 OHP Sheet is Improperly Set

Step Check point
Perform the preliminary inspection.
Parts to inspect:
1
FRONT OHP SENSOR, REAR OHP SENSOR, MCU
PWB
Isolation: Engine or Controller?
Run the Engine test print or diagnostic test print.
2
(10 sheets for each of single and continuous print)

Are the outputs normal?
Check: White edge of the OHP sheet

3
Is a break in the white edge of the OHP sheet
smeared or lodged with any foreign matter?
Check: FRONT OHP SENSOR, REAR OHP SENSOR

Is the surface of the FRONT OHP SENSOR or
4
REAR OHP SENSOR smeared or lodged with any
foreign matter?
Check: Paper path

5
Is the paper path smeared or lodged with any foreign
matter?
Check: FRONT OHP SENSOR

Is the FRONT OHP SENSOR properly functioning?
6
(Check it by using the diagnostic tool.)
Diag Tool: Digital Input Test
Device Code: 1D
Check: REAR OHP SENSOR

Is the REAR OHP SENSOR properly functioning?
7
(Check it by using the diagnostic tool.)
Diag Tool: Digital Input Test
Device Code: 1B
Chapter 5 Troubleshooting
Yes
Replace/reinstall the defective part(s).
Check the Controller PWB.
If the problem still occurs, go to step 3.
Replace the OHP sheet.
Remove the smear/ foreign matter.
Remove the smear/ foreign matter.
Go to Step 7.
Replace the MCU PWB.
Remedy
No
Go to Step 2.
Go to Step 3.
Go to Step 4.
Go to Step 5.
• With the diagnostic tool, go to step 6.
• Without the diagnostic tool, go to FIP-
2.12 "FRONT OHP SENSOR is
Defective".
If the problem still occurs, go to FIP-2.13
"REAR OHP SENSOR is Defective".
Go to FIP-2.12 "FRONT OHP SENSOR
is Defective".
Go to FIP-2.13 "REAR OHP SENSOR is
Defective".
Revision A
5-29