Power Saver Modes - Xerox WorkCentre 7132 User Manual

2 Product Overview
Before using the machine, press the TEST button. If the GFI is working properly, the
RESET button should pop up. If it does, press the RESET button.
NOTE: If the RESET button pops back up when you press it, or if power is not
restored by this procedure, contact the Xerox Welcome Center.

Power Saver Modes

The machine has energy saving features that significantly reduce power consumption
during periods of inactivity. The <Power Saver> button is located on the upper-right
portion of the control panel, and lights up when the power saving feature is enabled.
The power saving feature operates in the following modes.
• Low Power Mode
• Sleep Mode
Low Power Mode
The machine automatically switches to the Low Power Mode after a certain period of
time from the last copy, fax, scan, or print operation. In this mode, the touch screen is
turned off, and the Power Saver light is on. The Low Power Mode is cancelled when
the <Power Saver> button on the control panel is pressed, or a fax or print job is
received by the machine. The factory default setting of 15 minutes is customer
changeable within the range of 1 to 240 minutes.
For more information, refer to Auto Power Saver in the Setups chapter on page 222.
Sleep Mode
The machine automatically switches from the Low Power Mode to the Sleep Mode after
a further period of inactivity. The Sleep Mode has a reduced power consumption
compared to Low Power Mode. In this mode, the touch screen is turned off, and the
Power Saver light is on. The Sleep Mode is cancelled when the <Power Saver> button
40
<Power Saver>
light/button
Xerox WorkCentre 7132 User Guide