Audio Tones; Control Panel Select Tone; Control Panel Alert Tone; Machine Ready Tone - Xerox WorkCentre 7132 User Manual

Audio Tones

This feature allows you to select the volume level of tones to be generated at various
occasions. You can choose different volume levels for each item shown on the screen.
1.
Select [Audio Tones] on the
[Common Settings] screen.
2.
Change the required settings.
Use the side tabs to switch
between screens.
3.
Select [Close].

Control Panel Select Tone

Specifies the volume level of the tone generated when an appropriate button on the
control panel is pressed and its action is accepted.

Control Panel Alert Tone

Specifies the volume level of the tone generated when an inappropriate button on the
control panel is pressed.

Machine Ready Tone

Specifies the volume level of the tone generated when the machine becomes ready to
copy or print, for example, after the power is switched on.

Copy Job Complete Tone

Specifies the volume level of the tone generated when copying finishes successfully.

Non-Copy Job Complete Tone

Specifies the volume level of the tone generated when a job other than copying finishes
successfully.
Fault Tone
Specifies the volume level of the tone generated when a job did not finish properly.
Alert Tone
Specifies the volume level of the tone generated when a job is suspended due to an
error.
Out of Paper Warning Tone
Specifies the volume level of the tone generated when the machine runs out of paper.
Low Toner Alert Tone
Specifies the volume level of the tone generated when it is time to replace the toner
cartridge.
Xerox WorkCentre 7132 User Guide
Common Settings
223