Product Overview
2.
Press the power switch to the [ ] position to switch the power off.
Power Saver Modes
The device is installed with the Power Saver function that will automatically cut off the electricity to the
device if no copy or print data is received for a certain duration.
There are two Power Saver modes: Low Power mode and Sleep mode.
3.
Low Power Mode: The device's power is not turned OFF completely in Low Power mode. Instead, this
mode creates a balance between low power consumption and short warm-up time by controlling the
temperature of the fusing unit to a level midway between the power OFF temperature and the Ready
temperature.
4.
Sleep Mode: Sleep mode minimizes power consumption by shutting off the power to all components
except the controller. Warm-up time in Sleep mode is longer than in Low Power mode.
Entering Power Saver Modes
The display goes off, and the <Power Saver> button of the control panel lights up when the device is in an
Power Saver mode.
You can set the length of time to wait until the device enters Low Power/Sleep mode.
Low Power mode is set to 1 minutes and Sleep mode to 0 minutes as default.
You can set the amount of time the device waits before entering Low Power mode from 1 to 150 minutes,
and the amount of time the device waits before entering Sleep mode from 0 to 60 minutes.
The fusing unit life is largely influenced by power distribution time on the device. Setting the amount of
time the device waits before activating the Power Saver function to a long value will keep the device's
47
®
Xerox
DocuCentre
User Guide
®
SC2020
<Power Saver> button
Redial/Pause
Power Saver
Clear All
Stop
Start
Error
Data