Stapler Faults - Xerox WorkCentre 7132 User Manual

Stapler Faults

Stapler Faults
Below describes stapler troubles when the Finisher (optional) is installed.
Follow the procedures on the following pages when copies are not stapled or when
staples are bent. Contact your Xerox Welcome Center if the problem persists after you
have tried the following solutions.
Unstapled Bent staple
If staples are stapled on the copies in the manner shown in the figures below, contact
your Xerox Welcome Center.
One side of staple rising up Staple bent in reverse direction
Flattened staple Entire staple rising up
Staple rising up with
center pressed in
Xerox WorkCentre 7132 User Guide 393