Default Settings On The Express Setup Page - Cisco M10-RM Software Manual

Assigning Basic Settings
•
•
Step 7 Click Apply to save your settings.
Click Network Interfaces to browse to the Network Interfaces Summary page.
Step 8
Click the radio interface to browse to the Network Interfaces: Radio Status page.
Step 9
Click the Settings tab to browse to the Settings page for the radio interface.
Step 10
Click Enable to enable the radio.
Step 11
Click Apply.
Step 12
Your wireless device is now running but probably requires additional configuring to conform to your
network's operational and security requirements. Consult the chapters in this manual for the information
you need to complete the configuration.
Note

Default Settings on the Express Setup Page

Table 4-1
Table 4-1
Setting
Host Name
Configuration Server Protocol
IP Address
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
4-14
Optimize Radio Network for—Use this setting to select either preconfigured settings for the
wireless device radio or customized settings for the wireless device radio.
– Throughput—Maximizes the data volume handled by the wireless device, but might reduce its
range.
– Range—Maximizes the wireless device's range but might reduce throughput.
– Default—Sets the default values for the access point.
– Custom—The wireless device uses the settings you enter on the Network Interfaces. Clicking
Custom takes you to the Network Interfaces:
Radio-802.11b Settings page.
Radio-802.11b Settings page.
Radio-802.11n Settings page (1250).
Radio-802.11n Settings page (1250)
Aironet Extensions—Enable this setting if there are only Cisco Aironetwireless devices on your
wireless LAN.
You can restore 1100, 1200, 1240, and 1250 series access points to factory defaults by
unplugging the power jack and plugging it back in while holding down the Mode button for a
few seconds, or until the Status LED turns amber.
lists the default settings for the settings on the Express Setup page.
Default Settings on the Express Setup Page
Chapter 4
Default
ap
DHCP
Assigned by DHCP by default; see the
Behavior" section on page 4-4
address behavior on the access point
Configuring the Access Point for the First Time
"Default IP Address
for a description of default IP
OL-14209-01