Copying Configuration Files By Using Rcp - Cisco M10-RM Software Manual

Working with Configuration Files
Command
Step 1
Step 2
Step 3
configure terminal
Step 4
ip ftp username username
Step 5 ip ftp password password
Step 6 end
Step 7 copy system:running-config
ftp:[[[//[username[:password]@]location]/directory]
/filename]
or
copy nvram:startup-config
ftp:[[[//[username[:password]@]location]/directory]
/filename]
This example shows how to copy the running configuration file named ap2-confg to the netadmin1
directory on the remote host with an IP address of 172.16.101.101:
ap# copy system:running-config ftp://netadmin1:mypass@172.16.101.101/ap2-confg
Write file ap2-confg on host 172.16.101.101?[confirm]
Building configuration...[OK]
Connected to 172.16.101.101
ap#
This example shows how to store a startup configuration file on a server by using FTP to copy the file:
ap# configure terminal
ap(config)# ip ftp username netadmin2
ap(config)# ip ftp password mypass
ap(config)# end
ap# copy nvram:startup-config ftp:
Remote host[]? 172.16.101.101
Name of configuration file to write [ap2-confg]?
Write file ap2-confg on host 172.16.101.101?[confirm]
![OK]

Copying Configuration Files by Using RCP

The Remote Copy Protocol (RCP) provides another method of downloading, uploading, and copying
configuration files between remote hosts and the access point. Unlike TFTP, which uses User Datagram
Protocol (UDP), a connectionless protocol, RCP uses TCP, which is connection-oriented.
To use RCP to copy files, the server from or to which you will be copying files must support RCP. The
RCP copy commands rely on the rsh server (or daemon) on the remote system. To copy files by using
RCP, you do not need to create a server for file distribution as you do with TFTP. You only need to have
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
20-14
Chapter 20
Purpose
Verify that the FTP server is properly configured by
referring to the "Preparing to Download or Upload a
Configuration File by Using FTP" section on page
Log into the access point through a Telnet session.
Enter global configuration mode.
This step is required only if you override the default remote
username or password (see Steps 4, 5, and 6).
(Optional) Change the default remote username.
(Optional) Change the default password.
Return to privileged EXEC mode.
Using FTP, store the access point running or startup
configuration file to the specified location.
Managing Firmware and Configurations
20-12.
OL-14209-01