Cisco M10-RM Software Manual page 314

Configuring VLANs
Command
Step 3
ssid ssid-string
Step 4
vlan vlan-id
Step 5
exit
Step 6 interface dot11radio 0.x |
1.xslot/port.x
Step 7 encapsulation dot1q vlan-id
[native]
Step 8 exit
Step 9 interface fastEthernet0.x
Step 10
encapsulation dot1q vlan-id
[native]
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
14-6
Purpose
Create an SSID and enter SSID configuration mode for the new
SSID. The SSID can consist of up to 32 alphanumeric
characters. SSIDs are case sensitive.
The SSID can consist of up to 32 alphanumeric, case-sensitive,
characters.
The first character can not contain the following characters:
Exclamation point (!)
•
Pound sign (#)
•
Semicolon (;)
•
The following characters are invalid and cannot be used in an
SSID:
Plus sign (+)
•
Right bracket (])
•
• Front slash (/)
• Quotation mark (")
• Tab
Trailing spaces
•
You use the ssid command's authentication options to
Note
configure an authentication type for each SSID. See
Chapter 11, "Configuring Authentication Types,"
instructions on configuring authentication types.
(Optional) Assign the SSID to a VLAN on your network. Client
devices that associate using the SSID are grouped into this
VLAN. Enter a VLAN ID from 1 to 4095. You can assign only
one SSID to a VLAN.
If your network uses VLAN names, you can also assign
Tip
names to the VLANs on your access point. See the
"Assigning Names to VLANs" section on page 14-7
instructions.
Return to interface configuration mode for the radio interface.
Enter interface configuration mode for the radio VLAN sub
interface.
Enable a VLAN on the radio interface.
(Optional) Designate the VLAN as the native VLAN. On many
networks, the native VLAN is VLAN 1.
Return to global configuration mode.
Enter interface configuration mode for the Ethernet VLAN
subinterface.
Enable a VLAN on the Ethernet interface.
(Optional) Designate the VLAN as the native VLAN. On many
networks, the native VLAN is VLAN 1.
Chapter 14 Configuring VLANs
for
for
OL-14209-01