Default Settings On The Express Setup Page - Cisco Aironet 1240AG Series Hardware Installation Manual

Assigning Basic Settings

Default Settings on the Express Setup Page

Table 3-1
Table 3-1
Setting
System Name
Configuration Server Protocol
IP Address
IP Subnet Mask
Default Gateway
Role in Radio Network
Web Server
SNMP Community
Optimize Radio Network for
Aironet Extensions
Enabling the Radio Interfaces
In Cisco IOS Release 12.3(4)JA or
default SSID. You must create an SSID and enable the radios before the access point will allow wireless
associations from other devices. These changes to the default configuration improve the security of
newly installed access points. Refer to the
instructions on configuring the SSID.
To enable the radio interfaces, follow these instructions:
Use your web-browser to access your access point.
Step 1
When the Summary Status page displays, click Network Interfaces > Radio0-802.11b or Network
Step 2
Interfaces > Radio0-802.11g and the radio status page displays.
Click Settings and the radio settings page displays.
Step 3
Click Enable in the Enable Radio field.
Step 4
Click Apply.
Step 5
Click Radio1-802.11A and the radio status page displays.
Step 6
Repeat Steps 3 to 5.
Step 7
Step 8 Close your web-browser.
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
3-8
D r a f t 1 A - C I S C O C O N F I D E N T I A L
lists the default settings for the settings on the Express Setup page.
Default Settings on the Express Setup Page
Chapter 3
Default
ap
DHCP
Assigned by DHCP
Note The access point does not have a default IP address.
Assigned by DHCP
Assigned by DHCP
Access point (root)
Standard (HTTP)
defaultCommunity
Throughput
Enable
later, the access point radios are disabled by default, and there is no
"Configuring Basic Security Settings" section on page 3-9
Configuring the Access Point for the First Time
for
OL-7293-01