Default Settings On The Express Setup Page - Cisco Aironet 1130AG Series Hardware Installation Manual

Assigning Basic Settings
Click Apply to save your settings. If you changed the IP address, you lose your connection to the access
Step 7
point. Browse to the new IP address to reconnect to the access point.
Your access point is now running but probably requires additional configuring to conform to your
network's operational and security requirements. Consult the chapters in this manual for the information
you need to complete the configuration.
Note

Default Settings on the Express Setup Page

Table 3-1
Table 3-1
Setting
System Name
Configuration Server Protocol
IP Address
IP Subnet Mask
Default Gateway
Radio Service Set ID (SSID)
Broadcast SSID in Beacon
Role in Radio Network
Optimize Radio Network for
Aironet Extensions
SNMP Community
1. When you assign multiple SSIDs, this setting no longer appears.
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
3-8
C I S C O C O N F I D E N T I A L -
You can restore the access point to its factory defaults by unplugging the power jack and
plugging it back in while holding the Mode button down until the Ethernet LED turns an amber
color (approximately 2 to 3 seconds).
lists the default settings for the settings on the Express Setup page.
Default Settings on the Express Setup Page
Chapter 3
D r a f t 2
Default
ap
DHCP
Assigned by DHCP
Note The access point does not have a default IP address.
Assigned by DHCP
Assigned by DHCP
tsunami
1
Yes
Access point (root)
Throughput
Enable
defaultCommunity
Configuring the Access Point for the First Time
OL-6226-01