Displaying Monitor Mode Statistics - Cisco M10-RM Software Manual

Chapter 12 Configuring WDS, Fast Secure Roaming, Radio Management, and Wireless Intrusion Detection Services
Beginning in privileged EXEC mode, follow these steps to configure the access point to capture and
forward 802.11 frames:
Command
Step 1 configure terminal
Step 2
interface dot11radio {0 | 1}
Step 3 monitor frames endpoint ip
address IP-address port UDP-port
[truncate truncation-length]
Step 4
end

Displaying Monitor Mode Statistics

Use the show wlccp ap rm monitor statistics global configuration command to display statistics on
captured frames.
This example shows output from the command:
ap# show wlccp ap rm monitor statistics
Dot11Radio 0
====================
WLAN Monitoring
Endpoint IP address
Endpoint port
Frame Truncation Length
Dot11Radio 1
====================
WLAN Monitoring
WLAN Monitor Statistics
==========================
Total No. of frames rx by DOT11 driver
Total No. of Dot11 no buffers
Total No. of Frames Q Failed
Current No. of frames in SCAN Q
Total No. of frames captured
Total No. of data frames captured
Total No. of control frames captured
Total No. of Mgmt frames captured
Total No. of CRC errored frames captured: 0
Total No. of captured frames forwarded
Total No. of captured frames forward failed : 0
Use the clear wlccp ap rm statistics command to clear the monitor mode statistics.
OL-14209-01
Purpose
Enter global configuration mode.
Enter interface configuration mode for the radio interface.
The 2.4-GHz radio and the 2.4-GHz 802.11n radio is 0.
The 5-GHz radio and the 5-GHz 802.11n radio is 1.
Configure the radio for monitor mode. Enter the IP address and
the UDP port on the WIDS engine on your network.
(Optional) Configure a maximum length in bytes for each
•
forwarded frame. The access point truncates frames longer
than this value. The default length is 128 bytes.
Return to privileged EXEC mode.
: Enabled
: 10.91.107.19
: 2000
: 535 bytes
: Disabled
: 58475
: 361
: 0
: 0
: 0
: 425
: 1957
: 20287
: 23179
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
Configuring Access Points to Participate in WIDS
12-31