Cli Configuration Example; Deleting An Https Certificate - Cisco M10-RM Software Manual

Chapter 2 Using the Web-Browser Interface
Figure 2-12
Click OK.
Step 21
On the Certificate window shown in
Step 22
Step 23 On the Security Alert window shown in
Step 24 The access point login window appears and you must log into the access point again. The default user
name is Cisco (case-sensitive) and the default password is Cisco (case-sensitive).

CLI Configuration Example

This example shows the CLI commands that are equivalent to the steps listed in the
for Secure Browsing" section on page
AP# configure terminal
AP(config)# hostname ap1100
AP(config)# ip domain name company.com
AP(config)# ip name-server 10.91.107.18
AP(config)# ip http secure-server
AP(config)# end
In this example, the access point system name is ap1100, the domain name is company.com, and the IP
address of the DNS server is 10.91.107.18.
For complete descriptions of the commands used in this example, consult the Cisco IOS Commands
Master List, Release 12.3. Click this link to browse to the master list of commands:
http://www.cisco.com/en/US/docs/ios/mcl/123mcl/TD-Book-Wrapper.html

Deleting an HTTPS Certificate

The access point generates a certificate automatically when you enable HTTPS. However, if you need to
change the access point's fully qualified domain name (FQDN) or you need to add an FQDN after
enabling HTTPS, you might need to delete the certificate. Follow these steps:
Browse to the Services: HTTP Web Server page.
Step 1
Uncheck the Enable Secure (HTTPS) Browsing check box to disable HTTPS.
Step 2
Click Delete Certificate to delete the certificate.
Step 3
Re-enable HTTPS. The access point generates a new certificate using the new FQDN.
Step 4
OL-14209-01
Import Successful Window
Figure
Figure
2-5:
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
2-7, which is still displayed, click OK.
2-6, click Yes.
Enabling HTTPS for Secure Browsing
"Enabling HTTPS
2-13