Cisco M10-RM Software Manual page 480

802.11 Subsystem Messages
Error Message DOT114-NO_MBSSID_BACKUP_VLAN: "Backup VLANs cannot be configured if
MBSSID is not enabled. %s not started.
Explanation
Recommended Action
Error Message IF-4-MISPLACED_VLAN_TAG: "Detected a misplaced VLAN tag on source
Interface %. Dropping packet.
Explanation
be parsed correctly. The received packet was encapsulated or deencapsulated incorrectly.
Recommended Action
Error Message DOT11-2-FW_LOAD_NET: "Interface %s cannot load on boot. Place image in
flash root directory and reload."
Explanation
Recommended Action
Error Message DOT11-4-FW_LOAD_DELAYED: "Interface %s, network filesys not ready.
Delaying firmware (%s) load."
Explanation
into the indicated interface. Loading the identified firmware file has been delayed.
Recommended Action
firmware.
Error Message DOT11-3-FLASH_UNKNOWN_RADIO: "Interface %s has an unknown radio."
Explanation
into the indicated interface.
Recommended Action
Error Message DOT11-4-UPLINK_ESTABLISHED: "Interface %s associated to AP %s %e %s.
Explanation
associate to the indicated repeater and traffic can pass.
Recommended Action
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
C-10
To enable a backup VLAN, MBSSID mode should be configured.
Configure MBSSID on the device.
Received an 802.1Q VLAN tag was detected on the indicated interface which could not
None
The radio images cannot be loaded from a network when the access point boots.
Place the image on the root directory of the flash file system.
The network filesystem was not running or not ready when trying to flash new firmware
Make sure the network is up and ready before attempting to reflash the new
The radio type could not be determined when the user attempted to flash new firmware
Reboot the system and see if the firmware upgrade completes.
The indicated repeater has associated to the indicated root access point. Clients can now
None.
Appendix C Error and Event Messages
OL-14209-01