Default Settings On The Express Setup Page - Cisco Aironet 1300 Series Installation Manual

Assigning Basic Settings
•
Click Apply to save your settings. If you changed the IP address, you lose your connection to the bridge.
Step 7
Browse to the new IP address to reconnect to the bridge.
Note

Default Settings on the Express Setup Page

Table 5-1
Table 5-1
Setting
System Name
Configuration Server Protocol
IP Address
IP Subnet Mask
Default Gateway
SNMP
SSID
Broadcast SSID in Beacon
Role in Radio Network
Optimize Radio Network for
1. During Install Mode, the SSID is autoinstall.
2. After a static IP address is assigned or the role is changed from Install, the SSID is tsunami.
Cisco Aironet 1300 Series Bridge Hardware Installation Guide
5-8
C I S C O C O N F I D E N T I A L - F i r s t D r a f t
Optimize Radio Network for—Use this setting to select either preconfigured settings for the bridge
radio or customized settings for the bridge radio.
Throughput—Maximizes the data volume handled by the bridge but might reduce its range.
–
Range—Maximizes the bridge's range but might reduce throughput.
–
Default—The bridge retains default radio settings that are designed to provide good range and
–
throughput for most bridges.
Custom—The bridge uses settings you enter on the Network Interfaces: Radio-802.11b
–
Settings page. Clicking Custom takes you to the Network Interfaces: Radio-802.11b Settings
page.
You can restore the bridge to its factory defaults by unplugging the power injector's power jack
and plugging it back in while holding down the Mode button for a few seconds, or until the Status
LED turns amber.
lists the default settings for the settings on the Express Setup page.
Default Settings on the Express Setup Page
Chapter 5
Default
Bridge
DHCP
Assigned by DHCP (default setting); if DHCP is disabled, the
default setting is 10.0.0.1
Assigned by DHCP (default setting); if DHCP is disabled, the
default setting is 255.255.255.224
Assigned by DHCP (default setting); if DHCP is disabled, the
default setting is 0.0.0.0
defaultCommunity
Read Only
1 2
autoinstall or tsunami
Yes
Install
Throughput
Configuring the Bridge for the First Time
OL-5048-01