Default Settings On The Express Setup Page - Cisco AIR-LAP1142N-A-K9 Getting Started Manual

Throughput—Maximizes data volume handled by the access point but might reduce
–
its range.
Range—Maximizes the access point range but might reduce throughput.
–
Default—The access point uses its default data rate settings for the radio selected.
–
Custom—The access point uses settings that you enter on the radio settings page.
–
Clicking Custom takes you to the radio settings page.
• Aironet Extensions—By default, the access point uses Cisco Aironet 802.11 extensions to
detect the capabilities of Cisco Aironet client devices and to support features that require
specific interaction between the access point and associated client devices. Aironet
extensions must be enabled to support features such as load balancing, Message Integrity
Check (MIC), Temporal Key Integrity Check (TKIP), Repeater Mode, and World Mode.
Disabling Aironet Extensions disables the features mentioned above, but it sometimes
improves the ability of non-Cisco client devices to associate to the access point.

Default Settings on the Express Setup Page

Table 1 lists the default settings on the Express Setup page.
Table 1 Express Setup Default Settings
Setting
System Name
Configuration Server Protocol
IP Address
IP Subnet Mask
Default Gateway
Role in Radio Network
Web Server
SNMP Community
Optimize Radio Network for
Aironet Extensions
Default
ap
DHCP
Assigned by DHCP
The access point does not have a default IP address.
Note
Assigned by DHCP
Assigned by DHCP
Access point
Standard (HTTP)
default Community
Throughput
Enable
13