Configuring Snmp - Cisco M10-RM Software Manual

Configuring SNMP

This chapter describes how to configure the Simple Network Management Protocol (SNMP) on your
access point.
For complete syntax and usage information for the commands used in this chapter, refer to the Cisco IOS
Note
Command Reference for Cisco Aironet Access Points and Bridges for this release and to the Cisco IOS
Configuration Fundamentals Command Reference for Release 12.3.
This chapter consists of these sections:
Understanding SNMP, page 18-2
•
Configuring SNMP, page 18-5
•
Displaying SNMP Status, page 18-12
•
OL-14209-01
C H A P T E R
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
18
18-1