Cli Configuration Example; Configuring The Authentication Server To Support Wds - Cisco M10-RM Software Manual

Cisco ios releases 12.4(10b)ja and 12.3(8)jec
Hide thumbs Also See for M10-RM:
Table of Contents

Advertisement

Chapter 12
Configuring WDS, Fast Secure Roaming, Radio Management, and Wireless Intrusion Detection Services
The access points that you configure to interact with the WDS automatically perform these steps:

CLI Configuration Example

This example shows the CLI commands that are equivalent to the steps listed in the
Points to use the WDS Device" section on page
AP# configure terminal
AP(config)# wlccp ap username APWestWing password 7 wes7win8
AP(config)# end
In this example, the access point is enabled to interact with the WDS device, and it authenticates to your
authentication server using APWestWing as its username and wes7win8 as its password. You must
configure the same username and password pair when you set up the access point as a client on your
authentication server.
For complete descriptions of the commands used in this example, consult the Cisco IOS Command
Reference for Cisco Aironet Access Points and Bridges.

Configuring the Authentication Server to Support WDS

The WDS device and all access points participating in WDS must authenticate to your authentication
server. On your server, you must configure usernames and passwords for the access points and a
username and password for the WDS device.
If your server runs Cisco ACS, follow these steps to configure the access points on your server:
Log into Cisco Secure ACS and click Network Configuration to browse to the Network Configuration
Step 1
page. You must use the Network Configuration page to create an entry for the WDS device.
shows the Network Configuration page.
OL-14209-01
Discover and track the current WDS device and relay WDS advertisements to the wireless LAN.
Authenticate with the WDS device and establish a secure communication channel to the WDS
device.
Register associated client devices with the WDS device.
12-14:
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
Configuring WDS
"Configuring Access
Figure 12-9
12-15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Aironet series

Table of Contents