Snmp Error Messages - Cisco M10-RM Software Manual

SNMP Error Messages

Error Message SENSOR-3-VOLT_NORMAL: System sensor "d"("d") is now operating under
NORMAL voltage
Error Message SENSOR-3-VOLT_WARNING: Voltage monitor "d"("d") has exceeded voltage
thresholds
SNMP Error Messages
Error Message SNMP-3-AUTHFAILIPV6: Authentication failure for SNMP request from
hostUnrecognized format ' %P'
Error Message SNMP-3-INPUT_QFULL_ERR: Packet dropped due to input queue full
Error Message SNMP-3-INTERRUPT_CALL_ERR: "s" function, cannot be called from
interrupt handler
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
C-28
Explanation One of the measured environmental test points is under normal
operating voltage.
None required
Recommended Action
Explanation One of the measured voltage test points indicates that voltage is out of normal range.
Check Power Supplies or contact TAC
Explanation
An SNMP request was sent by this host which was not properly authenticated.
Explanation
Recommended Action Make sure that the community/user name used in the SNMP req has been
configured on the router.
Snmp packet dropped due to input queue full error
Explanation
Recommended Action Use the command show snmp to see the number of packets dropped. Stop any
SNMP access to the device until the error condition is recovered.
This message indicates that a call has been made to the function from an interrupt
Explanation
handler. This is not permitted because it will fail and device will reboot down the stack in malloc
call.
If this messages recurs, copy it exactly as it appears and report it to your
Recommended Action
technical support representative.
Appendix C Error and Event Messages
OL-14209-01