Cisco M10-RM Software Manual page 492

Local Authenticator Messages
Error Message DOT1X-SHIM-3-UNSUPPORTED_KM: "Unsupported key management: %X."
Explanation
management type was found.
Recommended Action
Error Message DPT1X-SHIM-4-PLUMB_KEY_ERR: "Unable to plumb keys - %s."
Explanation
Recommended Action
Error Message DOT1X-SHIM-3-PKT_TX_ERR: "Unable to tx packet -%s."
Explanation
Recommended Action
Error Message DOT1X-SHIM-3-ENCAP_ERR: "Packet encap failed for %e."
Explanation
The packet encapsulation failed.
Recommended Action
Error Message DOT1X-SHIM-3-SUPP_START_FAIL: "Unable to start supplicant on %s."
Explanation
the indicated interface.
Recommended Action
Error Message DOT1X-SHIM=3-NO_UPLINK: "No uplink found for %s."
Explanation
encountered where an uplink was expected, but not found.
Recommended Action
Error Message Information Group rad_acct: Radius server <ip address> is responding
again (previously dead). Error Group acct: No active radius servers found. Id 106
Explanation
access point.This command is configured to set an interval during which the access point does not
attempt to use servers that do not respond. Thus avoids the time needed to wait for a request to time
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
C-22
Am error occurred during the initialization of the shim layer. An unsupported key
None.
An unexpected error occurred when the shim layer tried to plumb the keys.
None.
An unexpected error occurred when the shim layer tried to transmit the dot1x packet.
None
An unexpected error occurred when the shim layer tried to transmit the dot1x packet.
None.
An unexpected error occurred when the shim layer tried to start the dot1x suppliant on
None.
While processing a dot1x event or message on a dot11 interface, a situation was
None.
This message is seen if the radius-server deadtime 10 command is configured on the
Appendix C Error and Event Messages
OL-14209-01