Configure Rts Threshold And Retries - Cisco M10-RM Software Manual

Chapter 6 Configuring Radio Settings
Command
Step 4
beacon dtim-period value
Step 5
end
Step 6 copy running-config startup-config (Optional) Save your entries in the configuration file.

Configure RTS Threshold and Retries

The RTS threshold determines the packet size at which the wireless device issues a request to send (RTS)
before sending the packet. A low RTS Threshold setting can be useful in areas where many client devices
are associating with the wireless device, or in areas where the clients are far apart and can detect only
the wireless device and not each other. You can enter a setting ranging from 0 to 23472347 bytes.
Maximum RTS retries is the maximum number of times the wireless device issues an RTS before
stopping the attempt to send the packet over the radio. Enter a value from 1 to 128.
The default RTS threshold is 2347 for all access points and bridges, and the default maximum RTS
retries setting is 3264. Beginning in privileged EXEC mode, follow these steps to configure the RTS
threshold and maximum RTS retries:
Command
Step 1 configure terminal
Step 2 interface dot11radio { 0 | 1slot/port
}
Step 3
rts threshold value
Step 4
rts retries value
Step 5 end
Step 6 copy running-config startup-config (Optional) Save your entries in the configuration file.
Use the no form of the command to reset the RTS settings to defaults.
OL-14209-01
Purpose
Set the DTIM. Enter a value in Kilomicroseconds.
Return to privileged EXEC mode.
Purpose
Enter global configuration mode.
Enter interface configuration mode for the radio interface.
The 2.4-GHz radio and the 2.4-GHz 802.11n radio is 0.
The 5-GHz radio and the 5-GHz 802.11n radio is 1.
Set the RTS threshold. Enter an RTS threshold from 0 to
23472347.
Set the maximum RTS retries. Enter a setting from 1 to 128.
Return to privileged EXEC mode.
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
Configure RTS Threshold and Retries
6-31