Cisco M10-RM Software Manual page 479

Appendix C Error and Event Messages
Error Message DOT11-6-DFS_SCAN_START: "DFS: Scanning frequency %d MHz for %d
seconds."
Explanation
Recommended Action
Error Message DOT11-6-DFS_TRIGGERED: "DFS: triggered on frequency %d MHz."
Explanation
Recommended Action
a new channel will be selected.
Error Message DOT11-4-DFS_STORE_FAIL: "DFS: could not store the frequency
statistics."
Explanation
Recommended Action
Error Message DOT11-4-NO_SSID: "No SSIDs configured, %d not started."
Explanation
radio to run.
Recommended Action
Error Message DOT11-4-NO_SSID_VLAN: "No SSID with VLAN configured. %s not started."
Explanation
Recommended Action
the VLAN on the indicated interface.
Error Message DOT11-4-NO_MBSSID_VLAN: "No VLANs configured in MBSSID mode. %s not
started."
Explanation
Recommended Action
Error Message DOT11-4-NO_MBSSID_SHR_AUTH: "More than 1 SSID with shared
authentication method in non-MBSSID mode % is down".
Explanation
enabled.
Recommended Action
to open configuration.
OL-14209-01
The device has begun its DFS scanning process.
None.
DFS has detected RADAR signals on the indicated frequency.
None. The channel will be placed on the non-occupancy list for 30 minutes and
A failure occurred writing the DFS statistics to flash.
None.
All SSIDs were deleted from the configuration. At least one must be configured for the
Configure at least one SSID on the access point.
No SSID was configured for a VLAN. The indicated interface was not started.
At least one SSID must be configured per VLAN. Add at least one SSID for
No VLAN configured in MBSSID mode. The indicated interface was not started.
Add at least one SSID with the VLAN on the indicated interface configuration.
Not more than 1 SSID can have shared authentication method when MBSSID is not
Remove Dot11Radio radio interface or change authentication mode for SSID
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
802.11 Subsystem Messages
C-9